Vinyl Squeegee
€4.90
High-quality mixed application squeegee with one scratch-resistant felt edge side, and another flexible plastic side that allows you to press down and push out water during wet application.
For applying all types of stickers, decals, vinyl films, window tint, car wrapping, etc.
The ideal tool to make vinyl installation easier and prevent air bubbles when applying your vinyl films.
Sold individually with an extra replacement felt strip.
Guarantees - Secure Payments
Shipping Policy
Returns / Withdrawal Policy
Felt Squeegee
Ideal for applying your vinyls, stickers, and scratch-resistant window films.
Its felt edge provides flexibility, softness, and durability, designed for installing all types of vinyl and preventing air bubbles without damaging the vinyl. The opposite side of the squeegee is rigid, allowing you to tuck the vinyl into hard-to-reach areas.
Composition: Polypropylene
Dimensions: Width 10 cm x Length 7.2 cm
ℹ️ APPLICATION INSTRUCTIONS:
The application surface must be clean, degreased, and smooth. Avoid applying after a water-repellent treatment. Recommended application temperature is +18°C (+64°F) or above.
For winter application, the adhesive hardens if the bodywork or glass is freezing cold; heat the surface (glass or bodywork) with a hairdryer.
Rub firmly over the transparent transfer tape with a squeegee or a microfiber cloth before removing it.
To apply stickers on a treated car (PPF, ceramic coating, or wax), the method depends on the desired finish level:
Standard method (thorough degreasing): Wipe the exact application area with Isopropyl Alcohol (IPA) concentrated at 70-90% or a panel wipe. This temporarily breaks down the hydrophobic top coat or removes the wax so the adhesive can grip.
Permanent method (local polishing): If the ceramic coating is very fresh and hard, light polishing with a finishing compound is required to strip the ceramic layer on that spot. Then degrease with IPA before applying the sticker.
Ultra-hydrophobic PPF: On high-end self-healing PPF, IPA alone may not be enough. Use a vinyl Adhesion Promoter (such as 3M Primer 94), applying it with a brush only where the adhesive will sit.
Once the sticker is applied, a ceramic coating or wax can be reapplied around and over the sticker to uniform the protection.
For optimal durability: It is possible to apply a clear coat over the sticker after light sanding (de-glossing).
Pressure washing: Avoid spraying closer than 30 cm (12 inches). Do not use rotary nozzle lances or ultra-high pressure on small isolated elements if the sticker is unvarnished. The best method is hand washing with a soft brush and car shampoo, as in detailing, then rinsing with clean water.
Download the full sticker application guide under the "Attached Documents" tab.
RAC-BLACK
Data sheet
- Compositions
- Polypropylène
Customers who bought this product also bought:
Comments (0)
No customer reviews for the moment.
High-quality mixed application squeegee with one scratch-resistant felt edge side, and another flexible plastic side that allows you to press down and push out water during wet application.
For applying all types of stickers, decals, vinyl films, window tint, car wrapping, etc.
The ideal tool to make vinyl installation easier and prevent air bubbles when applying your vinyl films.
Sold individually with an extra replacement felt strip.
